INMAR SAR 380 - 12' 6" Orca Hypalon Inflatable Boat with Rapid Deploy Floor, Short Shaft, & Hand Glued Seams

(0) No Reviews yet


  • Length 12' 6"
  • Beam 6' 5"
  • Weight w/ floor: 195 lbs.
  • Weight capacity: 6 persons / 1,750 lbs.
  • Max HP / Weight: 30 HP / 175 lbs / Short shaft (15")
  • Recommended HP: 20 HP
  • Tube diameter 20"
  • Air chambers: 4 chambers w/ individual inflation & over inflation valves + Keel.
  • Fabric: Hypalon (CSM), Orca 866 (military grade), 1670 dtex
  • Seam glue: Solvent-based polychloroprene rubber adhesive
  • Factory warranty: 5 years recreational / 2 year commercial
  • Performance Tubes - Speed & stability (Optional)
  • Self bailers (1) *optional High flow scupper can be added

Standard Features:
  • Marine plywood transom, epoxy coated
  • Transom splash guards
  • Aluminum engine mounting plate
  • Reinforcement on tube transom attachments
  • Standard pop-up self bailers (internal release)
  • All around rub strake, flat profile, black
  • Rubbing strakes for beaching on keel and tubes
  • 8 carry handles, soft handle neoprene covered nylon
  • Bow handle (Stainless)
  • Exterior/Interior lifelines (Peripheral)
  • 11 Interior tie down D-rings (Stainless steel)
  • 2 large tow rings on bow (Stainless steel)
  • 4 large tow rings on rear tubes(Stainless steel)
  • Foot pump with hose & gauge (1) included
  • Repair kit (1) included
  • Storage bag
  • Paddle set (Alum. shaft, plastic blade)

Shipping Information
  • Boat package dimensions: 52X34X20
  • Boat package weight: 193 lbs.

Military Duty
  • Hypalon Fabric
  • Hand glued Seams
  • Rubber based material
  • Extreme Climates

Hypalon Material:
Years of experience have shown that Hypalon material with its rubber based coating can last for years. We have chosen only the best materials in the market for INMAR inflatable boats. Orca's Hypalon is produced in France and is today's leader in the military world for the construction of inflatable boats. They have been proven for years to stand up again and again. Orca offers a 10 year manufacturer's warranty against delimitation and manufacturer defects. Hypalon material uses a different glue and process type that is not easily affected by extreme climates. Hypalon, is the most difficult of the three materials to prepare for seam adhesion and must be all be done by hand. This labor intensive process reflects on the higher costs of all Hypalon boats, but they are the most rugged for any climate.

Ratings & Reviews

No reviews available

Be the first to Write a Review